Although we primarily keep bees for pollination, we’d be lying if we didn’t admit that at some point we also hoped to harvest at least some honey. Last year, as the colonies were building up, we left the honey stores with the bees.
We’ve had a smackeral or two of honey along the way, but not nearly enough to keep your average bear happy.
In early spring we thought we might be able to harvest quite a bit of honey, but swarm season set off with a roar, and due to poor timing on our part, we lost most of our spring honey to the swarms.
Finally though, this last weekend we managed to eek out an actual honey harvest!
This was our last opportunity for the year to take any honey, if there was enough, so the bees would still have time to restock their reserves before the weather changes.
Most of the hives were doing well, except for Salvia, as we mentioned in our last post. Relative to the population of bees, Salvia had quite a bit of honey, so we took a few frames from that hive. The Lavender and Chamomile hives both seemed to have enough stocked for this time of year, but neither seemed to have what we’d call a ‘surplus’, so we left their honey alone.
Then we looked into the Rosemary hive. This colony, split from Salvia in February, got an early start to the season. By April, Rosemary was building up fast. After the swarms, and reshuffling of resources around the apiary between the hives, there really wasn’t any extra honey to take though. However, we added a Queen excluder to a couple of the hives that seemed most likely to produce a surplus later in the year.
We’re still undecided whether we’ll continue to use Queen excluders routinely or not. For the Rosemary hive it seemed to work great. But for Chamomile, a less robust colony, despite checkerboarding some nectar frames above the excluder, the bees refused to move up.
As soon as we pulled the lid from the Rosemary hive, we were bombarded by some grumpy guard bees. This hive is not short on population, and definitely not short on guards!
As it’s August, it’s also robbing season, so the bees are certainly in a more heightened state of alert. In fact, before we did anything this weekend, we re-installed the robbing screens at the hive entrances. We learned our robbing lessons last year, and we know that taking honey can exacerbate robbing in the apiary.
It was clear the boxes above the Queen excluder were completely full of honey in Rosemary hive, even the outer frames which the bees often don’t bother drawing out, were jam packed with capped honey.
We removed those boxes to assess stores closer to the brood nest. Before taking honey, we want to be sure we aren’t leaving the bees short, and we also wanted to be sure the Queen was still producing plenty of healthy brood.
However, as we got down to the top of the brood nest, the bees really had decided we were up to no good, and even the smoker wasn’t enough to get everyone to calm down. In fact, for the first time I was actually stung THROUGH my leather gloves! The rest of the inspection was just enough to see capped brood, larvae and eggs, and then we swiftly closed the hive back up.
We didn’t leave the apiary empty handed though…
As late summer is robbing season, to minimize the frenzy in the apiary, once the honey frames were bee-free, we quickly tucked them away inside a large marine cooler. This not only protected the frames from the 90 degree heat outside, but the cooler was also impenetrable by bees looking to steal honey, which helped keep the apiary calm and civil. The cooler also has handles at each end, which means the heavy honey haul can be carried by TWO people, instead of one!
Once we hauled the harvest back to the house, it was time to think about getting set up to harvest the frames.
Some of the honey had been stored on foundationless frames, so that honey was simply cut loose from the frame, and cut into sections as comb-honey.
I grew up with honey on the comb, but comb honey seems to be somewhat more rare here. Our neighbors though, who we sourced our first bees from, are happy to have honey in this form, so we sent a large chunk of it in their direction.
The rest of the honey would need to be extracted from the combs though.
Although for small volumes either a crush-and-strain method, or gravity method, can be used to harvest the honey, we had enough frames this time that we thought an extractor would make harvesting the honey a little easier.
We were fortunate to be able to borrow an extractor, and a decapping tank.
Setting the extractor up in a bee-free environment was critical, or we’d be mobbed by bees. The decapping tank was set up next to the extractor, and the harvest bucket was set under the honey gate. In the top of the bucket we set a double sieve to strain out any pieces of wax during the extraction.
Once we had everything set up, we cut the cappings from the honey combs.
Any cappings that weren’t cut by the decapping knife, were popped open with a cappings scratcher.
Once uncapped, each frame was set into the basket in the extractor.
Making sure the frames are balanced, much as you would balance a centrifuge, the extraction could begin.
It took a little while, cranking the handle, flipping the frames, and cranking again, but then the honey started to flow!
As frames were emptied, they were set in the decapping tank, along with the bulk of the cappings, so any excess honey that drained out wouldn’t be wasted.
As much work as it’s taken to get even this amount of honey, we weren’t wasting a drop!
It was interesting to note as we decapped more frames, how some of the honey was a significantly different color on one part of the frame versus another.
Makes you wonder what flowers they were foraging on for each of the different colors of honey.
We wanted to keep the honey from the Salvia and Rosemary hives separate, as there can be quite a difference in either flavor, or color, between hives in an apiary.
Once all the frames from one hive had gone through the extractor, the next step was to bottle that honey, before moving on to the next hive’s honey extraction.
With the gate at the bottom of the bucket, and an extra pair of hands, bottling went very quickly.
By the end of the day the counters in the kitchen were getting crowded.
Although this wasn’t a huge honey harvest, we’ve certainly been able to restock our supplies, and are very grateful that this year we have a harvest at all. We’re always a little judicious about taking honey from the bees, as we’d rather the bees ate honey, than sugar water, during the winter months. Bees are struggling enough, we don’t to need make matters worse.
The flavor, and color of this honey, is amazing though. A neighbor asked what we thought the bees had been foraging on to make the honey so flavorful. Presumably it’s a little bit of everything growing up here. From thyme and lavender in the gardens, to various assorted weeds, vegetable blossoms, native plants like the tarweeds and asters that have been in bloom recently, and whatever may be in bloom in nearby gardens.
The flavor of Rosemary’s honey is very complex, and difficult to ascribe to anything specific. It has rich caramel overtones, with hints of floral and citrus-like notes. Salvia’s honey is very similar, just slightly less robust in flavor.
Homegrown honey is truly special, and simply doesn’t compare to mass produced commercial honeys. Seeing the occasional speck of wax in one of our jars, is almost comforting. We know it’s local, it’s pure, it’s strained, not filtered, and depending on the time of year, or the hive, it can be almost any color in the spectrum of honey. You never quite know what you’re going get.
We can’t wait to see how our next harvest looks, and tastes!
“When you go in search of honey you must expect to be stung by bees.” ~ Joseph Joubert